![]() Because employees on a scaffold may be engaged in work that exposes workers to falling objects of a wide variety of shapes and sizes, the appropriate falling object protection needs to be determined on a case-by-case basis. This requirement does not necessarily satisfy the requirement of §1926.451(h)(1), because personnel hoists are not designed for the same activities as scaffolds, and would therefore not necessarily be subject to the same types of falling object hazards. Section 1926.552(c)(7) addresses the requirements for the covering that must be provided for the top of every personnel hoist. ![]() If none of the methods can achieve this, the hazard must be abated by removing the objects from the area from which they might fall. Thus, whichever protective method is chosen, it must be sufficiently strong to deflect or contain the potential falling objects. When the falling objects are too large, heavy or massive to be contained or deflected by any of the above-listed measures, the employer shall place such potential falling objects away from the edge of the surface from which they could fall and shall secure those materials as necessary to prevent their falling. Section 1926.451(h)(1) requires that: In addition to wearing hardhats each employee on a scaffold shall be provided with additional protection from falling hand tools, debris, and other small objects through the installation of toeboards, screens, or guardrail systems, or through the erection of debris nets, catch platforms, or canopy structures that contain or deflect the falling objects. However, in order to fulfill the requirements of the standard - that is, to abate the struck-by hazard presented by potential falling objects, the falling object protection systems would need to be sufficiently strong to withstand the potential impact of the objects above the scaffold. Question 2: What are the structural (performance) requirements for the following types of falling object protection mentioned in §1926.451(h)(1): canopy structure, debris net, and catch platform? Would this requirement be satisfied by following the requirements of §1926.552(c)(7)?Īnswer 2: OSHA does not set forth specific performance requirements in the scaffolding standard for falling object protection systems. Question 1: What is a "structural member" of a scaffold?Īnswer 1: A "structural member" of a scaffold is any part of the walking/working surface of the scaffold, as well as the supports for the walking/working surface, including but not limited to uprights, suspension ropes, bracing, outrigger beams, access ladders, etc. ![]() Re: Single-point suspension scaffold safety. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |